Free Calculator USA

Home › Blog › Home & Building

Concrete Calculator Guide: Estimate Slab Volume and Mix Ratios

By Free Calculator USA · Published · 4 min read

Ordering the right amount of concrete avoids paying for waste and avoids running short in the middle of a pour, which can leave a weak seam. A concrete calculator turns your slab size into cubic yards or bags, and this guide shows the math behind it.

Skip the math? Use the Concrete Calculator, it is free and nothing you type leaves your device.

The short answer

Multiply length x width x thickness (all in feet) to get cubic feet, then divide by 27 to get cubic yards. Add 5% to 10% extra.

What is a concrete calculator used for?

A concrete calculator estimates how much concrete a project needs, in cubic feet, cubic yards or bags. It is used for slabs, patios, driveways, walkways, footings and steps.

How to estimate concrete volume for a slab

  1. Measure the length and width in feet.
  2. Convert the thickness from inches to feet by dividing by 12. A 4 inch slab is 0.33 ft.
  3. Multiply length x width x thickness to get cubic feet.
  4. Divide by 27 to get cubic yards, the unit ready-mix trucks sell by.
  5. Add 5% to 10% for uneven ground and spillage.

Worked example

A patio 10 ft x 12 ft and 4 inches thick:

StepCalculationResult
Volume10 x 12 x 0.33about 40 cubic feet
Cubic yards40 / 27about 1.5 cubic yards
With 10% extra1.5 x 1.1about 1.65 cubic yards

How many bags do I need?

Bags are labeled with their yield. As a rough guide, an 80 lb bag makes about 0.6 cubic feet and a 60 lb bag about 0.45 cubic feet. The patio above needs about 44 cubic feet with the extra, which is roughly 74 bags of 80 lb. For a job that size, ready-mix delivery is usually easier. Always check the yield printed on the bag you buy.

Understanding concrete mix ratios for beginners

Concrete mixed on site is cement, sand and gravel (aggregate) plus water. Ratios are written as cement : sand : gravel.

RatioCommon use
1 : 2 : 3Stronger mix for slabs, driveways and structural work
1 : 2 : 4General purpose, footpaths and light slabs
1 : 3 : 6Non-structural fill and bases

The right strength depends on the job and local code, so confirm with your contractor or building department for anything structural. Too much water weakens concrete, so add it gradually.

Common slab thickness guide

Frequently asked questions

What is a concrete calculator used for?

It estimates the concrete needed, in cubic feet, cubic yards or bags, for slabs, footings, patios and driveways.

How do I calculate concrete for a slab?

Length x width x thickness in feet gives cubic feet. Divide by 27 for cubic yards.

How thick should a concrete slab be?

About 4 inches for patios and walkways, and 5 to 6 inches for driveways.

Should I order extra concrete?

Yes. About 5% to 10% extra covers uneven ground, spillage and slightly thicker edges.

Related calculators

Keep reading

Browse the whole blog, all calculators or all guides.

This article is general information, not engineering or construction advice. Follow local building codes and the product instructions, and ask a licensed professional for structural work. Spotted a mistake? Tell us and we will fix it.